An Easier Way To Mate, Part Deux (With Video!)
Last November, I posted a tip on how to more easily mate components using an Alt-Drag technique. A reader had a question about it, so I thought I would create a video demonstrating it. I hope it helps. (Tip: switch to full screen or view in HD on Vimeo)
This is my first attempt at video in quite a while, and I was impressed with the results! Sorry about the audio, but I don’t think it’s too bad.
Like it/hate it? Let me know what you think in the comments!











[...] Keep Reading: An Easier Way To Mate, Part Deux (With Video!) | CADFanatic.com. [...]
Very helpful. Thanks
Very helpful. Thanks
Leave your response!
Subscribe to CADFanatic by Email
Categories
Friends
Corporate Blogs
SolidWorks Blogs
Design Resources
Awards
PhD Online Programs
Disclosures & Disclaimers
I use DS SolidWorks Corp software daily in my full-time job. However, DS SolidWorks Corp provides me with a non-commercial license of SolidWorks Premium for ongoing educational and research purposes. I am in occasional contact with employees at DS SolidWorks Corp., and am sometimes asked to provide feedback on new products or programs.
I am also in occasional contact with other companies that may be mentioned on this site. Some of these companies occasionally provide non-commercially licensed software and/or hardware for review or feedback.
I am not compensated for any of the above efforts.
Any revenue generated via affiliate links or ads on this site is incidental and have no bearing on this site's content.
Additional disclosures and/or disclaimers may be made in individual articles as warranted.